Idiomas disponibles
Idiomas disponibles
Fig. 17
8. Install the replacement auger by following the above steps
in reverse order (Fig. 18).
Fig. 18
Replacing the Belt
m
WARNING!
Make sure to turn off the unit and remove
the battery before performing any maintenance task on your
cordless snow shovel.
1. Disassemble the left side cover by removing the
five (5) screws that hold it in place (Fig. 11).
2. To remove the old belt from the drive wheel, use one hand
to slowly turn the auger while use the other hand to lift the
belt (Fig. 19).
Fig. 19
3. Replace a new belt in place. Place the left side cover back
into position and refasten the five (5) screws.
Replacing the Scraper Bar
m
WARNING!
the battery before performing any maintenance task on your
cordless snow shovel.
1. Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper bar to the base of
the unit (Fig. 20).
Auger
Fig. 20
Remove
the screws
2. Remove the old scraper bar (Fig. 21).
Fig. 21
Scraper bar
3. Install the new scraper bar and fasten it securely to the
housing with the four (4) screws (Fig. 22).
Fig. 22
Drive
wheel
Fix with
Belt
the screws
Auger
Lubricating the Cordless Snow Shovel
This cordless snow shovel does not need lubrication. All
bearings are lubricated at the factory for the life of the product.
13
Make sure to turn off the unit and remove
