Idiomas disponibles
Idiomas disponibles
IF THESE SOLUTIONS DO NOT SOLVE THE PRObLEM cONTAcT YOUR AUTHORIZED SERVIcE DEALER.
Problem
Engine will not start.
Engine does not reach full speed and
emits excessive smoke.
Engine starts, runs, and accelerates
but will not idle.
TROUbLESHOOTINg
Possible cause
No spark.
No fuel.
Engine is flooded.
Starter rope pulls harder now than
when new.
Check lubricant fuel mixture.
Air filter is dirty.
Carburetor out of adjustment.
Idle speed screw on carburetor needs
adjustment.
Page 13 — English
Solution
Check spark. Remove spark plug. Re-
attach the spark plug cap and lay spark
plug on metal cylinder. Pull the starter
rope and watch for spark at spark plug
tip. If there is no spark, repeat test with
a new spark plug.
Push primer bulb until bulb is full of
fuel. If bulb does not fill, primary fuel
delivery system is blocked. Contact
a servicing dealer. If primer bulb fills,
engine may be flooded, proceed to
next item.
Remove spark plug, turn trimmer so
spark plug hole is aimed at the ground.
Rotate the choke dial to "RUN" posi-
tion and pull starter cord 10 to 15
times. This will clear excess fuel from
engine. Clean and reinstall spark plug.
Pull starter three times with choke dial
at "RUN". If engine does not start, ro-
tate choke dial to "FULL CHOKE" posi-
tion and repeat normal starting proce-
dure. If engine still fails to start, repeat
procedure with a new spark plug.
Contact an authorized servicing dealer.
Use fresh fuel and the correct 2-cycle
lubricant mix.
Clean air filter. Refer to cleaning the
Air Filter Screen earlier in this manual.
Contact an authorized servicing dealer.
Turn idle speed screw clockwise to
increase idle speed. See figure 16.
