Idiomas disponibles
Idiomas disponibles
PROGRAMMING MODE -
Diagnostic tests:
This program has been added for testing the washer and detecting errors.
Entering the test mode
Data Name
1. Entering
Entering
programming mode
the test mode
2. Hot
3. Start
1.
According to pressing Start button, test move to the next step.
Number of times the
START button is pressed
None
1 time
Turns on all lamps and locks the door
2 times
Tumble Clockwise.
3 times
Low Speed Spin
4 times
High Speed Spin
5 times
Inlet valve for main water turns on.
6 times
Inlet valve for hot wash turns on.
Inlet valve for atomizing turns on (single model).
7 times
Inlet valve for softener turns on (stack model).
Inlet valve for bleach turns on (single model).
8 times
Inlet valve for atomizing/bleach turns on (stack model).
9 times
Tumble counter clockwise.
10 times
Heater turns on.
11 times
Turn on Circulation Pump.
12 times
Drain Pump turns on.
13 times
Turns on all lamps.
14 times
Button Checks.
15 times
High Speed Spin
16 times
17 times
NOTE
• Make sure the drum is empty when a diagnostic test is performed. Do not use
(display)
Button
Display
Check Point
PDA Signal Check
PROGRAMMING MODE - TEST MODE
TEST MODE
Description
Insert service card (card type)
Turn on/off toggle switch (coin type)
Press the Hot button. Then
in the display.
Enter the diagnostic test mode.
Displays
14:XX alternately (Version)
rpm (40~50)
rpm (600)
rpm (1150)
Water level frequency (255~)
Water level frequency (255~)
Water level frequency (255~)
Water level frequency (255~)
rpm (40~50)
Displays water temperature
Water level frequency (255~)
Water level frequency (255~)
Displays
14:XX alternately (Version)"
rpm (1150)
this function is not applied in
this machine
67
appears
Display
, 1U:XX, 1g:XX and
, 1U:XX, 1g:XX and
.
