Idiomas disponibles
Idiomas disponibles
Connecting the water lines
1
Untighten the upper connector screw.
Upper Connector
Fixing screw
- In case the diameter of the tap is large
remove the guide plate.
Guide plate
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
2
Push the upper connector up till the rubber
packing is in tight contact with the tap. Then
tighten the 4 screws.
Rubber packing
Upper Connector
Middle connector
Rubber
packing
Middle
connector
3
Connect the water supply hose to the
middle connector, pushing the plate down.
Connector
INSTALLATION INSTRUCTIONS
- Turn the middle connector not to have
water leaked.
- Make sure that the rubber seal is inside
the hose connector.
Hose connector
Upper
Connector
Water supply
hose
- To separate the water supply hose from
the middle connector shut off the tap.
Then pull the inlet hose down, pushing
the plate down.
- Your machine comes with only cold water
connection.
- Make sure that there are no kinks in the
hose and that it is not crushed.
15
Rubber seal
Plate
