External Display - SonoSite H-Universal Stand Manual Para El Usuario

To remove the TTC
1 Remove any attached transducers.
2 Disconnect the transducer connector from the system.
3 Pull out the knob on each of the two mounting brackets, and slide the TTC out.

External display

To adjust the angle of the external display
Adjust the external display to the proper angle prior to use.
1 Turn on the external display. (The switch is on the back.)
2 Turn on the ultrasound system.
3 Holding the display with both hands, rotate it forward or backward to the desired angle.
Use additional pressure if necessary.
Set screw
Figure 4 Adjust the angle of the external display
Caution:
8
A set screw controls the tightness of the display angle. To avoid damage to the
display, do not adjust the set screw. Turning the set screw loosens the display,
causing the display to drop.