Jonsered CS 2240S Manual De Instrucciones página 32

Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Jonsered chain saw models CS 2240 and CS 2240S. The
combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-11 Chainsaws and Z62.3-
11 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Guide bar and saw chain combinations
Chain saw models Jonsered CS 2240 and CS 2240S met the kickback performance requirements of ANSI B175.1-2012
when tested with the combinations of bars and saw chains listed below. The saw chain Jonsered H30 is also classified
as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2012. We
recommend to use only the listed combinations of bars and chains for chain saw models Jonsered CS 2240 and CS
2240S. Other chain saw models may not meet the kickback requirements when equipped with the listed bar and chain
combinations.
Length,
Pitch, inch
inch
13
15
0.325
16
18
Saw chain filing and file gauges
32 – English
TECHNICAL DATA
Guide bar
Thickness of drive
Max. nose radius
links, inch
0.050 10T
Saw chain
Drive link
Type
count
56
64
Jonsered H30
66
72
1153144-49 Rev.6 2016-12-23