Idiomas disponibles
Idiomas disponibles
Fig. 4
STAIN TEST AREA
4. Place the unit face-down on a clean protected surface. Measure from the top left to bottom right
corners and from the top right to bottom left corners. The measurements should be equal. If they
aren't, tap the bottom of the side panel on the longer side until the measurements are equal. Attach
the Back (P) to the sides, top, and lower sleeper with #6 x 5/8" Philtruss Screws (ZD) through the
predrilled holes in the back. See Figure 4.
Fig. 5a
B
T
D
A
5. Attach each Small Drawer Side (B) to the Small Drawer False Front (C) with two #8 x 1-1/4" Black
Screws (T) through the predrilled holes in the sides. The grooves for the Drawer Bottom must
line up. Slide the Drawer Bottom (D) into the grooves. Attach the Small Drawer End (A) to the
Sides in the same manner. Repeat the above steps for the two Large Drawers. See Figure 5a.
Square the drawers by measuring from the left front to right rear corners and from the right front to
left rear corners. The measurements should be equal. If one is longer, hold the drawer by the corners
on the longest line and squeeze them together until square. See Figure 5b.
Page 6 — 582Wd — 03/14
ZD
C
P
B
T
T
Fig. 5b
