Idiomas disponibles
Idiomas disponibles
IMPORTANT:
DO NOT APPLY FINISH BEFORE THE FINAL ASSEMBLY. If you do so, the areas that require glue will not bond well.
Before you apply finish to this product, read the enclosed Finishing Hints.
NOTE: More than one type of hardwood is used in this product, so be sure to test for your desired color.
Test for your desired color on:
a. Veneer parts: apply stain to the unexposed portion of the side panel. See Figure 1a.
b. Alder pieces: apply stain to the back of the base. See Figure 4.
The side panels have a compression
stamp on the bottom edge:
"L" for left, "R" for right.
Kb
Z2
U
Z2
U
U
STAIN TEST AREA
V
Read the instructions on How to Operate the Cam Lock System.
1. Install three Drawer Slides (Cabinet Side Left) (Z2) using #6 x 5/8" Undercut (Type 17) Screws (U)
in the three sets of two pre-punched holes in the Left Side (Kb). Insert a third screw in one of the
center holes in each of the slides. See Figure 1a.
Repeat for the Right Side (Lb) with Drawer Slides (Cabinet Side Right) (Z1).
Hammer Tack Glides (V) into the bottoms of both sides about one inch from the front and back
edges. See Figure 1a.
Insert a Cam Connector (Q) into each of the four holes in the underside of the Top (N). See Figure 1b.
Page 4 — 582Wd — 03/14
582Wd Palmer Nightstand
Assembly Instructions
Phillips Screwdriver, Tape Measure,
Tools Required:
Padded Hammer or Rubber Mallet, Wood Glue
Fig. 1a
Lb
U
U
U
U
U
U
V
Q
Q
Z1
Z1
The drawer slides will be stamped with an "L" for left or
an "R" for right in the center of the wheels. Or they will be
stamped about 3" from the wheel with: "CL" for cabinet
Left; "DL" for drawer left; "CR" for cabinet right; "DR" for
V
Q
Q
N
Fig. 1b
drawer right.
