Idiomas disponibles
Idiomas disponibles
replacement parts or
accessories that have
not been supplied or
approved by the man-
ufacturer.
ASSEMBLY
To assemble the Montessori tower Kit on the Cre-
scendo, the following components need to be
removed from the product:
• Baby chair;
• Upper footrest;
• Lower footrest;
• Seat area.
To remove the baby chair, the upper footrest and
the lower footrest, refer to the instructions found
in the user manual for the Crescendo Up and
Crescendo Lite. Keep the 8 small screws resulting
from the removal of the two footrests for the
subsequent assembly of the Montessori tower Kit.
Disconnect the seat area by acting on the un-
derlying lever and button (Fig. 1). Next, unscrew
the screws that connect it to the frame using the
Allen Key that was provided with the Crescendo
Up and Crescendo Lite (Fig. 2). Store the screws
for future reassembly of the seat area.
WARNING: Keep the screws out of reach of
children.
Install the support surface "A" as indicated in Figure
3. Fasten the base to the frame using the 4 small
screws that were previously removed from the
footrests (Fig. 4).
Remove the screws located under the backrest
on either side (Fig. 5).
Insert the left-right adaptors "B" on the respective
legs of the frame (Fig. 6).
Press the adaptor all the way upwards, verifying
proper alignment with the holes where the screws
will be inserted (Fig. 7). At this stage, fasten the
adaptor to the side leg using the screw that was
removed from the backrest (Fig. 8). Complete the
installation by inserting the screw "C", provided,
into the inner side hole (Fig. 9). Repeat the opera-
tion for the other adaptor as well (Fig. 10).
WARNING: The (longer) screws removed from the
seat area CANNOT be used to fasten the adaptors.
Install the protective bar on the adaptors (Fig.
11) and fasten it to the adaptors using the 2 small
screws removed from the footrests (Fig. 12).
WARNING: Be sure that all the screws have been
tightened properly before using the product.
Insert the plugs "E" into the holes located on both
sides of the structure until you hear a click (Fig. 13).
WARNING: Before using the product, ensure that
the hole cover plugs have been fastened correctly.
TIPS FOR CLEANING AND MAINTENANCE
Cleaning and maintenance operations must only
be carried out by an adult.
Cleaning
Clean the plastic and metal parts with a soft damp
cloth. Never use abrasive products, solvents, or
overly aggressive cleaning products. If the high-
chair comes into contact with water, dry the metal
parts to prevent the formation of rust.
Maintenance
Regularly inspect the product for signs of wear
and damage. In the case of damage, do not use
and keep out of reach of children.
WARRANTY
The product is guaranteed against any lack of
conformity under normal use as specified in the
instructions.
The warranty shall not therefore apply in the case
of damage caused by improper use, wear or ac-
cidental events.
For the duration of the warranty on conformity
defects please refer to the specific provisions of
national laws applicable in the country of purchase,
where provided
12
