Operation Modes - Stocker Titania E-40 TP Manual De Instrucciones

6
Pruning shears Titania E-40 TP
Please check that the pruning shears and batteries are clean and dry.
Place the battery onto the shears body by sliding it downwards until it clicks-in. To disconnect
the battery, push the two lateral buttons and pull upwards.
140
Art. 315
Pruning shears Titania E-40 TP
Assembly
Art. 315
Pruning shears Titania E-40 TP
Usage

Operation modes

Progressive cutting: The blades close progressively according to the movement of the trigger
controlled by the operator, thereby allowing a complete control over the cutting performance. By
releasing the trigger, the blades reopen completely.
Automatic cutting: The blades close completely whenever the trigger is pulled by the operator.
By releasing the trigger, the blades reopen completely.
Adjusting the maximum blade aperture: it is also possible to adjust the maximum aperture of
the blade on two levels, 40 or 30 mm, in order to optimize pruning times on thinner branches.
Security blade lock: it allows locking the blades in order to avoid that they open when the
trigger is pulled accidentally.
Anti-cut finger protection system: it is possible to activate the anti-cut system, which
prevents the blades from closing whenever the hand of the operator touches, also accidentally,
any part of the blade/anvil.
WARNING: The finder protection system is deactivated by default on your shears,
the operator must activate it. The system only works if the operator works with bare
hands, without gloves.
For further information about the product, please contact [email protected]
7
141