Idiomas disponibles
Idiomas disponibles
7
Operating instructions
Progressive cutting:
1.
Press the power button and wait for the LED screen to turn on and for the acoustic signal
(1 beep), then release.
2.
Press the trigger twice repeatedly to unlock the blades. The shears will emit three beeps
(beep-beep-beep) and open the blades.
3.
The shears will automatically enter progressive cutting mode. It is now possible to start
working.
Switching from progressive/automatic cutting mode:
1.
Turn off the shears.
2.
First, press the trigger and then the power button, hold for 3 seconds, and wait for the
second acoustic signal (beep).
3.
The shears will automatically enter the automatic cutting mode. During this operation, the
shears will automatically enter the blade lock mode.
4.
Press the trigger twice repeatedly to unlock the blades. It is now possible to start working.
5.
To return to progressive cutting mode, perform the same operation.
Adjusting the maximum aperture of the blade:
1.
Press and hold the trigger for 1.5 seconds and wait for the beep-beep and release.
2.
It is now possible to start working with the maximum aperture of the blade opposite (40 or
30 mm) to the one previously used.
Manual activation of the security lock/unlock of the blade:
1.
To activate the safety blade lock, press and hold the trigger for 3 seconds and wait for the
acoustic signal (beep-beep). During this operation, the blades will close completely. If you
pull the trigger, the blades do not move.
2.
To deactivate the safety blade lock, press the trigger twice repeatedly.
142
Art. 315
Pruning shears Titania E-40 TP
Usage
Art. 315
Pruning shears Titania E-40 TP
Usage
Anti-cut finger protection system:
The shears are supplied with the system deactivated.
1.
To activate the anti-cut finger protection system, press and hold the trigger for 13 seconds
and wait for the long beep (beeeep). During this operation, the shear will automatically
enter the blade lock mode.
2.
Press the trigger twice repeatedly to unlock the blades. It is now possible to start working
with the anti-cut finger protection system activated.
3.
To deactivate the system, perform the same operation.
Standby
1.
After 3 minutes of inactivity, the shears go into stand-by mode (safety blade lock) and emit
3 acoustic signals in rapid succession (beep-beep-beep).
2.
To deactivate the safety blade lock, press the trigger twice repeatedly.
Automatic switch-off
After 10 minutes of inactivity, the shears switch off automatically and emit 3 acoustic signals
(beep-beep-beep).
For further information about the product, please contact [email protected]
7
143
