Lenco LS-480 Manual De Usuario página 11

Turntable is spinning, but there is no sound, or sound not loud enough
• Stylus protector is still on.
• Tone arm is lift up by the lever.
• The Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo system's line input.
• Forget to connect the speaker to the turntable.
Distorted of inconsistent sound from one or both channels:
- Turntable is connected to wrong input of amplifier.
- Needle or cantilever damaged.
- Drive belt overstretched or dirty.
- Platter bearing without oil, dirty or damaged.
- Dust on stylus.
- MM/MC switch on pre-amplifier set incorrectly.
Record sounds too fast or too slow
• Wrong speed selected for the record.
Strong hum on phono input
• The cable is not grounded correctly.
• Turntable too close to speakers.
Remark:
To protect the stylus, the platter will Stop automatically if no music has been playing for 1 min. For lowering the
power consumption, the whole unit will switch to standby mode automatically if no music has been playing for
about 20 minutes.
To restart the unit, hold press the "ON/OFF, MODE" Button.
If your unit switches off regularly, this is no defect.
Guarantee
Lenco offers service and warranty in accordance to European law, which means that in case of repairs (both during
and after the warranty period) you should contact your local dealer.
Important note: It is not possible to send products that need repairs to Lenco directly.
Important note: If this unit is opened or accessed by a non-official service center in any way, the warranty expires.
This device is not suitable for professional use. In case of professional use, all warranty obligations of the
manufacturer will be voided.
Disclaimer
Updates to Firmware and/or hardware components are made regularly. Therefore some of the instruction,
specifications and pictures in this documentation may differ slightly from your particular situation. All items
described in this guide for illustration purposes only and may not apply to particular situation. No legal right or
- 11 -