Idiomas disponibles
Idiomas disponibles
PROBLEM
Engine will not start.
Engine lacks power.
DC receptacle does not work.
AC receptacle does not work.
Generator stops.
If problem persists after trying the above solutions, contact your nearest authorized service center for assistance.
The following symptoms may indicate problems that will affect the emissions level of the unit:
Hard starting or stalling after starting
Rough idle
Misfiring or backfiring under load
Afterburning (backfiring)
Black exhaust smoke or high fuel consumption
If you encounter any of these symptoms, have the unit inspected and repaired by the nearest authorized service center.
TROUBLESHOOTING
POSSIBLE CAUSE
Engine/choke lever is in run position.
No fuel.
Stale gasoline or water in gasoline.
Lubricant level is low.
Spark plug faulty, fouled, or improperly
gapped.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Dirty fuel filter.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Dirty air filter.
Circuit protector engaged
Item plugged in is defective.
Item plugged in is defective.
Generator is overloaded.
17 — English
SOLUTION
Move engine/choke lever to start position.
Fill fuel tank.
Drain entire system and refill with fresh
fuel.
Check engine lubricant level and fill, if
necessary.
Replace spark plug.
Drain fuel and carburetor. Refuel with
fresh gasoline.
Replace fuel filter or contact authorized
service center or contact authorized
service center.
Drain fuel and carburetor. Refuel with
fresh gasoline. If problem continues,
contact your nearest authorized service
center.
Clean or replace as needed.
Remove any load from the generator.
Turn the auto idle switch to off, then
depress the DC circuit breaker.
Try a different item.
Try a different item.
Remove loads and press the reset
button.
