Idiomas disponibles
Idiomas disponibles
Maintenance and care
Cooling system maintenance
IMPORTANT
To maintain proper engine operating temperature, cooling air must pass freely through the cylinder fin area. This flow
of air carries combustion heat away from the engine.
Overheating and engine seizure can occur when:
Air intakes are blocked, preventing cooling air from reaching the cylinder,
or
Dust and grass build up on the out side of the cylinder. This build-up insulates the engine and prevents the heat from
leaving.
Removal of cooling passage blockages or cleaning of cylinder fins is considered "Normal Maintenance". Any resultant
failure attributed to lack of maintenance is not warranted.
1. Cylinder fins
Cleaning silencer
1. Silencer
2. Silencer cover
Check fuel system
2. Air intake
3. Two bolts
Remove dust and dirt from between fins.
Before each use, remove accumulated debris from bottom en-
gine intake grille located between the fuel tank and starter.
Clean deposits from silencer and tighten two bolts.
IMPORTANT
Do not remove the silencer cover. If necessary, Please consult
your dealer.
Check before every use.
After refuelling, make sure fuel does not leak or exude from
around fuel pipe, fuel grommet or fuel tank cap.
In case of fuel leakage or exudation there is a danger of fire.
Stop using the machine immediately and request your dealer
to inspect or replace.
32
