Idiomas disponibles
Idiomas disponibles
1. Adjustment of right han-
dle inclination (for-
ward/ backward)
1. Bracket
2. Bolt M5×25
3. Convex of fitting plate
1. Bracket
2. Shield (for nylon line
cutting head)
3. Bolt M5×18
2. Adjustment of left han-
dle inclination (for-
ward/ backward)
3. To engine
4. Fitting plate
5. Notch of fitting plate
4. Cut off knife
5. Screw 5×12
Before you start
Adjust each inclination of right and left handles to adequate posi-
tion (easy to operate) and tighten firmly handle assembling bolt
(8 mm) and 4 right handle assembling bolts.Determine "Easy to
operate" position seeing illustration above.
Installation of bracket
Fit bracket to mounting portion of angle transmission and fix the
bracket by holding fitting plate pressed from beneath and tighten
4 bolts (M5×25) lightly.
Get notches and convexes of fitting plate to face corresponding
convexes and concaves of bracket, and fix bracket tightening 4
bolts (M5×25) securely.
Method to change shield (Consult your dealer.)
There are two types of shields: namely one used exclusively for
nylon line cutting head and another one used exclusively for met-
al blade. When using nylon line cutting head, use the shield for
nylon line cutting head.
Remove bolt (M5×18) on the right side of the shield and slide the
shield to the left and remove it. Put shield of another type into
groove and slide it to the right until it stops and be sure to fasten
with the removed bolt (M5×18).
Fit cut off knife to the shield for nylon line cutting head using
screw (5×12).
17
