Idiomas disponibles
Idiomas disponibles
Assembly
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Loop handle version
1. Loop handle
2. Screw M5×35
U-handle version
1. Handle assembling bracket (upper)
2. Handle assembling bolt (8 mm)
3. Washer
4. Handle assembling bracket (lower)
5. To engine
1. Wire fixing clips
2. Shaft tube
WARNING
3. Loop handle bracket
4. Nut
3. Throttle wire
Before you start
Before you start
Loop handle assembly
Assemble loop handle and bracket to drive shaft assembly.
Position handle in comfortable operating position and tighten
screws (M5×35).
Install the handle so that it does not hide any of the
safety decals.
U-handle assembly
Install handle assembling bracket (upper) in handle assembling
bracket (lower) and fix handle by tightening handle assembling
bolt (8 mm) lightly.
Adjust inclination of handle to adequate position (easy to oper-
ate) and tighten firmly handle assembling bolt (8 mm).
Install the handle so that it does not hide any of the
safety decals.
To eliminate loosening of throttle wire fix it to shaft tube (2 places)
and to right hand U-handle (1 place) with wire fixing clips.
17
CAUTION
CAUTION
