Idiomas disponibles
Idiomas disponibles
7
(1)
EV1116
J4
J3
CP
< 33 Ω
Normal
A
larm
EV1116
( ) 2
J4
J3
CP
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
EN: Installation Sheet
Introduction
The EV1116 series includes the EV1116 and EV1116AM PIR
motion sensors. They have a patented mirror, pyro and signal
processing technology.
WARNING!
The equipment is not earthed. Any
external circuit connected to the equipment must be
located within the same building and connected to a
protective earthing conductor.
Wire insulation of cables connected to the equipment must
conform to IEC 60332-1-2 and IEC 60332-1-3 or IEC 60332-
2-2, depending on the wire cross sectional area, or IEC TS
60695-11-21, regardless of cross sectional area. Alternatively,
such wires must comply with UL 2556 VW-1.
P/N 146251999-4-ML • REV M • ISS 10JUN21
J4
J3
J4
J3
J4
J3
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
EV1116AM
J4
J3
CP
< 33 Ω
Normal
A
larm
EV1116AM
J4
J3
CP
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
AM/TF
Installation guidelines
The technology used in these detectors resists false alarm
hazards. However, avoid potential causes of instability (see
Figure 1) such as:
•
Direct sunlight on the detector
•
Strong draughts onto the detector
•
Heat sources within the detector field of view
•
Animals within the detector field of view
•
Obscuring the detector field of view with large objects,
such as furniture
•
Objects within 50 cm (20 in.) of the anti-masking (AM)
detector
•
Installing two detectors facing each other and less than
50 cm (20 in.) apart (only AM detectors)
Installing the detector
Figure 7
(1): Standard connection (factory
default)
(2): Dual loop connection
CP: Control panel
J4
J3
J4
J3
J4
J3
CP
Ω
Normal
4.7 k
A
larm
9.4
kΩ
Tamper
Ω
Short
0
AM/TF
WT: Walk test
AM: Antimasking
D/N: Day/night
Rtest: Remote test
3 / 38
