Aritech 700 Serie Manual De Instrucciones

700 Series Conventional Point Detector
Installation Sheet
EN CS DA DE ES FI
1
3
EN: Installation Sheet
Description
The 700 Series Conventional Point Detectors are compatible
with with DB702 and DB702U mounting bases.
Table 1: 700 Series Conventional Point Detectors
Model Detector type
DP721I Optical Smoke Detector with Remote Indicator Output
DP721R Optical Smoke Detector with Relay Output
DP721RT Optical/Heat Multi Detector with Relay Output
DP721T
Optical/Heat Multi Detector with Remote Indicator Output
DT713-5 Heat Detector, 57° C fixed and rate of rise heat detector
DT713-5R Heat Detector, 57° C fixed and rate of rise heat detector
with relay output
DT713-7 Heat Detector, 70°C fixed and rate of rise heat detector
© 2021 Carrier. All rights reserved.
FR HU IT NL NO PL PT RO SV TR
2
4
Installation
Caution:
For general guidelines on system planning, design,
installation, commissioning, use and maintenance, refer to
CEN/TS 54-14 and to local regulations.
To install a detector:
1. Insert the detector head into the mounting base and rotate
it clockwise until it clicks into place.
The detector may be locked into the mounting base if required.
To do this remove the locking tab on the detector before
installation (Figure 1).
Every 700 Series base features a continuity link between LINE
IN (1) and LINE OUT (2) terminals of the conventional detector
circuit. The base is supplied with the link in closed position.
The link is enabled by default allowing you to check the zone
wiring using only the bases. The link will automatically
disconnect when a detector is inserted, allowing the panel to
generate a fault message when the detector is removed.
1 / 28 P/N 10-4226-501-1C70-09 • ISS 08JUN21