Color frame retaining clip
The color frame holder is equipped with a spring-loaded retaining clip that prevents color
frames and accessories from falling out.
WARNING! Hang the MUL TI PAR with the color frame retaining clip in the locked position.
1.Release the retaining clip by pushing it sideways. The retaining clip opens.
2.lnsert the color frame.
3.Press the retaining clip down until it locks.
Note: Use only color frames or top hats with 6.7-inch inside diameter.
Cleaning the reflector
The following recommendations are offered when cleaning and inspecting lenses and reflectors:
Do not use glass and window cleaners on the reflector. Chemicals in these cleaners will harm the reflective coating.
Do not use paper towels or harsh materials to wipe the reflector. These materials can scratch the surface of the reflector.
WARNING! Unplug the fixture before attempting to clean reflector .
1.Remove the lens so you can access the reflector from the front of the fixture. See Removing a lens on page 2
2.Remove dust with a blast of oil free air, or wipe with a clean, soft, lint-free cotton cloth. lf this is sufficient to remove
dust, go to step 5. Otherwise, continue to step 3.
3.Dampen a clean, soft, lint-free cotton cloth with a mild, soapy water solution and gently wipe the reflector.
4.Remove any soapy water residue with a clean, soft, lint-free cotton cloth dampened with water.
5.Reinstall a lens before using the fixture.
Installing the GKV Iamp
Always replace the lamp if it becomes damaged or deformed.
Verify that the GKV lamp you use is suitable for the voltage at your facility. 115,
120, 230, and 240 volt GKV lamps are available.
Caution! Operating lamps above their rated voltage reduces lamp life and can
cause premature lamp failure .
1.Disconnect the unit from power before installing the lamp.
Let lamp cool before changing .
WARNING!
2.Loosen the knurled bolt on the back of the lamp housing and pull the housing
straight out from the back of the fixture.
3.Remove the GKV lamp from its box, holding it by the base.
Note: To avoid premature lamp failure , do not touch the lamp glass with your
fingers. If you touch the lamp during installation, clean it carefully with
rubbing alcohol and a clean, lint -free cloth before operation .
4.Line up the flat sides of the lamp base with the brackets on either side of the
socket (Figure 2).
5.Push down on the lamp base until the lamp is firmly seated. Make sure that the
lamp is fully seated, with the bottom of the lamp heat sink flush to the lamp housing casting.
Caution! lmproperly installed lamps cause premature lamp failure and socket problems .
6.To reinstall the lamp housing, center it on the reflector and the bolt hole, then tighten the knurled bolt to secure the
lamp housing in place.
Lens identification
Lenses for the MULTI PAR come in four versions. The type or beam spread can be identified by the lens texture.
VNSP
Very narrow spot
Clear glass
15º Round beam shape
NSP
Narrow spot
Stipple glass
19º Round beam shape
- 2 -
HPL lamp
Lamp brackets
Knurled bolt
MFL
Medium flood
Fewer facets,sized 6x22mm
21º x34º Oblong beam shape
Retaining clip in
the locked position
Figure 1
Lamp housing
Figure 2
WFL
Wide flood
Many facets,sized 6x12mm
30º x51º Oblong beam shape
MULTIPAR 575/2