Mark MULTIPAR 575/2 Instrucciones De Usuario página 5

Changing MUL TI PAR lenses
Change lenses if they become cracked or badly scratched.Caution! Never operate the MUL TI P AR without a lens in place.
Installing a lens
1.Position the fixture with the front of the unit (the lens side) facing you, and tilted slightly(Figure 4)
2.Position the lens rotation ring with the spring clip at the top of the fixture, directly below the
retaining clip.
3.Hold the lens by the edge, and position it so the convex side faces the back of the fixture(Figure 3) .
Installing the lens with the convex side out will not impair the optics,but it will make
Note:
removing the lens dificult.
4.From the top of the fixture, slide the lens behind the lens catchers and position its base behind the
tabs on the bottom of the lens rotation ring.
5.Gently push the top of the lens inward until it snaps behind the spring clip.
Removing a lens
WARNING! Uuplug the fixture before attempting to remove or install a lens.
1.Source MULTI PAR lenses get hot while the unit is in operation.Let the fixture cool before
handling the lens.
2.Place the fixture on a flat, stable work surface. Do not install or remove lenses with the unit
hanging.
3.Position the lens rotation ring with the spring clip at the top of the unit, directly below the
retaining clip.
4.Tilt the front of the fixture down at least 45º .
5.Press the spring clip with your finger to release the lens(Figure 4 ).
6.Allow the lens to drop forward from under the clip.
7.When the lens drops,remove your finger, allowing the lens to slide forward until it rests on the
lens catchers (Figure 5 ) .
8.Carefully remove the lens from the fixture.
Selecting a Mounting Location
The fixture should be installed outside areas where persons may walk by or be seated.
1. Before rigging make sure that the installation area can hold a minimum point load of 10 times the fixture's weight.
2. Do not install the fixture on radiant-heating type area
3. Out of the way but within arm's reach, so you can operate it easily
4. Close enough to an AC outlet to use the attached power cord
5. When installing the device, make sure there is no highly inflammable material (decoration articles, etc.) within a distance
of min. 1.0M
6. For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture. You must only
use safety-ropes with screw-on carabines.
Warning: To reduce the likelihood of the injury or damage to person, mount it only on a stable and sturdy area.
Installation With Clamp
You can choose a appropriate clamp from your dealer to fix the fixture
to the mounting pipe(e.g.truss system), and adjust the position of the
fixture once it is mounted.(Figure 6)
1. Tightly fasten the clamp to the yoke with the provided yoke bolt and
lock washer.
2. Place the clamp on mounting pipe, then tighten the pipe bolt to secure it.
3. Loosen the clamp pan screw and rotate the yoke to the desired position.
4. Tighten the pan screw to lock the fixture into position.
5. Adjust the desired inclination-angle via the yoke and fix the Yoke locking knob.
6. Pull the safety-rope through the hole on the housing and over the mounting
pipe etc. Insert the end in the carabine and tighten the safety screw.
Safty Rope
Carabine
Safty Screw
Safty Hole
- 3 -
Tab
pipe (of truss)
Clamp
Pan screw
Pipe bolt
Yoke bolt
Yoke
Yoke locking
knob.
Figure 6
Retaining clip
Spring clip
Figure 3
Spring clip
Tab
Retaining clip
Figure 4
Lens
catcher
Figure 5
MULTIPAR 575/2