Cleaning And Maintenance - Mark PAR 56 ECO Manual De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

I nstalling/Procedure:
U
The projector should be installed outside areas where persons may
walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE
EXPERIENCE, including (but not limited to) calculation working
load limits, installation material being used, and periodic safety
inspection of all installation material and the projector. If you lack
these qualifications, do not attempt the installation yourself, but
instead use a professional structural rigger. Improper installation
can result in bodily injury or damage to property.
The projector has to be installed out of the reach of people.
If the projector shall be lowered from the ceiling or high joists,
professional trussing systems have to be used. The projector must
never be fixed swinging freely in the room.
Caution: Projectors may cause severe injuries when crashing down!
If you have doubts concerning the safety of a possible installation,
do NOT install the projector!
Before rigging make sure that the installation area can hold a
minimum point load of 10 times the projector's weight.
DANGER OF FIRE! When installing the device, make sure there is
no highly inflammable material (decoration articles, etc.) within a
distance of min. 0.5 M.
Mount the projector with the mounting-bracket to your trussing system using an appropriate clamp.
The hole in the mounting bracket has a diameter of 10 mm.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture.
You must only use safety-ropes with screw-on carabine. Pull the safety-rope through the hole in the
mounting-bracket and over the trussing system etc. Insert the end in the carabine and tighten the
safety screw.
Adjust the desired inclination-angle via the mounting-bracket and fix the fixation screws.
DANGER TO LIFE! Before taking into operation for the first time, the installation has to be approved
by an expert!
I nstalling /Connection with the mains
U
DANGER TO LIFE! The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
The earth has to be connected!
Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with
a minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
In general, lighting effects should not be connected to dimming-packs.
DANGER TO LIFE! Before taking into operation for the first time, the installation has to be approved
by an expert!
OPERATION:
After you connected the spot to the mains, you can control the spot via your lighting controller.

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected
by an expert after every tour year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected
by a skilled person once a year.
The following points have to be considered during the inspection:
PAR 56 ECO
Cable
Pin
Brown
Live
Blue
Neutral N
Yellow/Green Earth
User Manual/Manual de uso
International
L
Pag 3
Tabla de contenido
loading

Tabla de contenido