Pulmic PEGASUS 35 Manual De Uso página 6

PULMIC PEGASUS 35
1. INTRODUCTION AND USES
Read this manual carefully before starting to use the sprayer and pay special
attention to the maintenance recommendations, as well as their use for
correct operation and useful life.
The company reserves the rights to changes the composition of the product
without prior notice as well as its technical characteristics. No claims can be
derived from the data and illustrations in this manual. The original manual
is written in Spanish, so it will prevail over the rest, in case of conflict or
contradictions between other languages.
This sprayer is specially designed for use with phytosanitary products such
as fungicides, insecticides or herbicides (pH scale min. 5 - 14 max.). It can
be used both for gardening and small farms. In no case should it be used
to spray flammable or industrial products such as solvents, alkalis or acids.
2. COMPOSITION AND START-UP
Before starting work, you must finish charging the battery (during storage
it may have lost some of its charge). To do this, the battery must be
disconnected from the sprayer.
Plug the charger into the mains and connect it to the battery until it is fully
charged. When the charge level is full, the battery LEDs will stop flashing
and stay on.
The sprayer's operating temperature range is 1 ° to 40 °C.
To start working with PULMIC PEGASUS 35, press the 3S button and a green
light will turn on; the sprayer will start at speed 1 (low pressure), suitable for
herbicide treatments. Pressing a second time the indicator light will change
to orange light, corresponding to speed 2 (medium pressure), suitable
for herbicide and insecticide treatments. Pressing for the third time, the
indicator light will turn red, speed 3 (suitable for insecticidal and fungicidal
treatments). Pressing for the fourth time, the indicator light will turn off: the
equipment will stop and remain disconnected, ready to be used again when
required.
www.gruposanz.es
— 10 —
PULMIC PEGASUS 35
DO NOT FORGET TO DISCONNECT THE SPRAYER WHEN
FINISHING WORK.
Watch the product commissioning video through the following
link or QR:
www.tiny.cc/peg35-02-en
3. SAFETY RULES
1. Use appropriate protective equipment to avoid contact of plant
protection products with any part of the body.
2. Read the instructions contained in the product labels, use the appropriate
preparation and mixing utensils, after preparation wash your hands and
face, to avoid ingesting the product, do not eat, drink or smoke during
handling. Always respect the prescriptions and doses indicated on the
product labels.
3. Properly remove empty or leftover containers.
4. Do not spray on people, animals, or electrical installations. Avoid drifting
to neighboring fields and crops, as well as to sources, rivers and ponds.
Do not use against the wind.
5. Do not use flammable or combustion-promoting materials.
6. Do not use liquids with temperatures higher than 40 °C.
4. EU DECLARATION OF CONFORMITY
In compliance with the provisions of the Machinery Directive (2006/42/CEE)
and Industry Law 21/1992, the manufacturer declares that this equipment
has been designed and tested in such a way that it complies with the Health
and Hygiene regulations that apply to it and are enforceable. Harmonized
technical standards ISO 19932-1: 2013; ISO 4254-6: 2009; ISO 16119-1: 2013;
IEC 62133-2:2017; UNE-EN 60745-1:2007; Directive 2009/127/EC; RoHS.
All materials and components have passed the corresponding quality tests
to be assembled and put into service safely.
In Valencia, January 2023.
www.gruposanz.es
— 11 —