Idiomas disponibles
Idiomas disponibles
•
(4) Align the side panel with the 4 bolts M12x30 into the
cage nuts and partly tighten them
•
(5) Install the side panel with the 24 bolts M6x16 + sealing
washers M6.
•
(6) Disassemble the 4 bolts M12x30.
Fig. 4.4
Mounting of the side panel
Applies to:
Wallflex 2400
CSC
•
Repeat the instructions of paragraph 4.3.3 to install the
other side panel.
Applies to:
Wallflex 1200
SC
•
Repeat the instructions of paragraph 4.3.3 to install the
side panel
, with the exception of steps (4) and (6). To
16
align the panel, put two bolts M6x16 in the top corners
first. Then install the remaining 22 bolts.
4.3.4
Arm bracket
Applies to:
CSC
ATTENTION!
Make sure that you have installed the reinforcement
plate behind the side panel; refer to paragraph
4.3.1.
Fig. 4.5
•
Install the arm bracket on the filter unit with 4 bolts
M12x30
and washers M12.
17
15. You must remove them later on to install the arm bracket.
16. Wallflex 1200: blind side panel | Wallflex "SC": side panel with inlet flange +
non-return valve
17. The ones you used to align the side panel in step 4.3.3
86958015
.
15
2
1
3
<60 s
4 6
4x
5
24x
Fig. 4.5 Mounting of the arm bracket
Applies to:
Wallflex 2400
If applicable:
•
Do the same procedure for the other arm bracket.
Applies to:
Recommended installation height of the arm bracket: at
approx. 2-2,3 m from the floor (top of the wall bracket). Also
refer to the footnote on page 8.
•
Install the arm bracket(s) at the desired position on the
wall, preferably as close as possible to the filter unit.
4.4
Depending on the selected configuration, the package contains
a fan type Fan 3.0 or Fan 4.7. You can install the fan in
different positions to get the desired outlet direction;
- Fan 3.0: 6 possible directions
- Fan 4.7: 2 possible directions (left and right)
To install the fan, do the following.
Fig. 4.6
•
Put adhesive rubber strip (A) around the inlet opening on
top of the filter unit. Make sure that the strip does not
entirely cover the holes.
•
Disassemble the service panel (refer to Fig. 2.1F).
Fig. 4.6
CSC
SC
Extraction fan
Refer to Fig. III on page 95 for an overview of the
possible outlet directions.
Adhesive rubber strip
EN | 7
