Idiomas disponibles
Idiomas disponibles
4.7
Extraction arm
For assembly of the extraction arm(s), refer to the installation
manual of the PolyArticule, that is supplied with the product.
4.7.1
LL-5.5/24 | Manual on/off switch on the hood,
incl. LED working light (option)
•
Install the LL-5.5/24 in the hood of the extraction arm in
accordance with the instruction sheet that is supplied with
the product.
Subsequently:
Fig. 4.10
•
Feed the cable through the extraction arm to the rotating
flange (A).
•
Feed the cable through the grommet into the cable gland
(B).
•
Tighten the cable gland.
Fig. 4.10 Grommet + cable gland
Fig. 4.11
•
Release the hopper (D) to get access to the inside of the
unit.
•
"CSC" types only: Feed the cable through the
reinforcement plate (A).
•
Remove the blind plug (C) from the nearest (left or right)
cable gland (B), just below the indicator panel.
•
Feed the cable through the cable gland (B) inside the unit.
•
Tighten the cable gland.
CSC
Fig. 4.11 Cable connection
21. In case of a Wallflex 2400: use the left cable gland for the left arm and vice
versa
86958015
B
Fig. 4.12
•
Remove the cover of the indicator panel.
•
Cut the cable to the appropriate length.
•
Connect the cable as indicated below. The wire numbers
(#) correspond with those on the instruction sheet that is
supplied with the LL-5.5/24
Wire #
Colour
03
red
04
black
05
grey
06
blue
Fig. 4.12 Cable connection inside indicator panel
ATTENTION!
Before you proceed, make sure that all cable glands
are fully tightened, to prevent leakage of dust.
4.7.2
Inlet ducting
Applies to:
21
Fig. 4.13
•
Put adhesive rubber strip (G) around the opening of the
arm bracket. Make sure that the strip does not entirely
cover the holes.
•
Put the mounting flange (D) over the duct flange (C).
•
Put the bend (E) into the duct flange (C).
•
Put the other side of the bend (E) into the inlet flange
(B).
•
Install the mounting flange to the arm bracket with 4x
bolts M8 with 8x washers and 4x locknuts (F), that are
supplied with the extraction arm.
•
Make sure that all connections are airtight.
22. Manual on/off switch, incl. LED working light
23. Inlet flange + non-return valve (assembly)
.
22
X2
Connection
1
2
2
3
5
6
7
8
CSC
1
2
2
3
5
6
7
8
X1
23
EN | 9
