Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND CLEANING
It is recommended to the self-cleanin every two weeks if the water in the area is hard or semi-hard if
frequent use of the device is made
Before cleanin the steam iron ensure it is unplu ed from the power supply and has completely cooled down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as these
will dama e the surface.
Cleanin the soleplate; Do not use scourin pads or harsh cleaners on the soleplate as these will dama e
the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the soleplate,
simply wipe with soft damp cloth and wipe dry.
SELF CLEANING
Fill the half of the water reservoir.
Set the temperature control to its maximum position.
Insert the main plu into the wall socket.
Allow the iron to heat up until the indicator li ht turns o .
Unplu the steam iron.
Holdin the iron horizontally over the sink and press the button of Self clean, in case if not have this
button chan e the steam control to the maximum position.
Boilin water and steam will be ejected from the holes in soleplate with impurities washed out Move the
iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry durin stora e.
Is recommended to do the self-cleanin at least every two weeks.
ANTI CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate.
The resin filter is permanent and does not need replacin .
Please note:
Do not use chemical additives, scented substances or decalcifies. Failure to comply with the above-
mentioned re ulations leads to the loss of uarantee.
AUTO SHUT OFF
This steam iron is fitted with an automatic switch-o system. This stops the iron from heatin up, if
the iron is restin on its sole of the iron and is not moved for about 30 seconds, there will be a warnin
beep and the control lamp for the automatic switch-o temperature / automatic switch-o control lamp
flashes. The iron will stop heatin up, to deactivate the automatic switch o , lift up the iron and move it
ently from side to side. the control lamp for the automatic switch-o temperature/automatic switch-o
control lamp oes out and the iron will heat up a ain.
If the iron is restin on its base and is not moved for about 8 minutes, there will be a warnin beep and
the control lamp for the automatic switch-o lamp flashes. The iron will stop heatin up. To deactivate
19
