UFESA PV3300 DELUX AUTOSTOP Manual De Instrucciones página 18

Do not fill hi her than mark on the water tank, in order to avoid spillin out of water.
The water tank should be emptied after each use.
SPRAYING
As lon as there is enou h water in the water tank, you may use the spray button at any temperature
settin durin steam or dry ironin .
Press the spray button several times to activate the pump while you are ironin .
STEAM IRONING
Set the temperature control dial to the desired position in accordance with the manufacturer' s label. The
indicator li ht will turn on until the temperature is reached. Then the indicator li ht will turn o .
Set the variable steam control to the desired position.
CAUTION: Avoid comin in contact with ejected steam.
DRY IRONING
The steam iron can be used on the dry settin with or without water in the water tank, it is best to avoid
havin the water tank full while dry ironin .
Turn the variable steam control to the minimum position.
Select the settin on the temperature control dial best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a lon time, it is hot and there is no water. Do not refill it
with water until the steam iron cools down.
SHOT OF STEAM
The shot of steam feature provides additional steam for removin stubborn wrinkles.
Turn o the variable steam control to the min position
Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leaka e from the soleplate, do not keep the powerful steam button in continuously
and wait almost 5 seconds between pressures.
VERTICAL IRONING
By pressin the shot-steam button at intervals you can also iron vertically (curtains, hun arments, etc.)
NOTE: To prevent water leaka e from the soleplate, do not keep the powerful steam button in continuously
and wait almost 5 seconds between pressures.
WHEN YOU FINISHED IRONING
Set the temperature dial to the minimum position.
Remove the main plu from the wall socket.
Stand the iron on heel rest.
18