Selco RI 1000 Instrucciones De Uso página 8

1 WARNING
Before performing any operation on the machine,
make sure that you have thoroughly read and
understood the contents of this booklet.
Do not perform modifications or maintenance
operations which are not prescribed.
The manufacturer cannot be held responsible for damages to
persons or property caused by misuse or non-application of the
contents of this booklet by the user.
Please consult qualified personnel if you have any
doubts or difficulties in using the equipment.
2 INSTALLATION
Connection for MIG/MAG welding
System for automation and robotics
- Connect the CAN-BUS signal cable for the control of external
devices (such as RC, RI...) to the appropriate connector (1).
Insert the connector and rotate the ring nut clockwise until
the parts are properly secured.
- Connect the power cable (2) to the appropriate outlet (3).
Insert the plug and turn clockwise until all parts are secured.
8
- Connect the signal cable (4) to the appropriate connector (5).
Insert the connector and screw the ring nut clockwise until all
parts are secured.
- Connect the gas hose (6) to the pressure reducing valve of the
cylinder (7) or to the gas supply connection.
- Connect the water pipe (blue colored
quick connector of the cooling unit.
- Connect the water pipe (red colored
connector of the cooling unit.
- Connect the MIG/MAG torch (8) to the central adapter (9),
ensuring that the fastening ring is fully tightened.
- Connect the water pipe (10) (red colored
to the inlet quick connector (11) of the cooling unit.
- Connect the water pipe (12) (blue colored
to the outlet quick connector (13) of the cooling unit.
- Connect the earth clamp (14) to the negative socket (-) (15) of
the power source.
) to the outlet
) to the inlet quick
) of the torch
) of the torch