EINHELL TE-AG 18/115 Li Manual De Instrucciones página 15

b) Flange nut (7)
6.6 Motor
The motor must be provided with good ventilation
during operation, which means that the air vents
must be kept clean at all times.
6.7 Grinding wheels
•
The grinding or cutting wheel must never be
bigger than the stipulated diameter.
•
Check the specified rotating speed of the
grinding or cutting wheel before use.
•
The maximum speed of the grinding or
cutting wheel used must be higher than the
idle speed of the angle grinder.
•
Only use grinding or cutting wheels which are
approved for a minimum rotating speed of
8,500 RPM and for a circumferential speed of
170 ft/s (52 m/s).
•
Check the direction of rotation when you use
diamond cutting wheels. The directional arrow
on the diamond cutting wheel must point in
the direction in which the tool rotates.
Take special care that the grinding wheels are
properly stored and transported. Ensure that the
grinding wheels are never exposed to shock, jolts
or sharp edges (for example during transport or
storage in a toolbox). This could cause damage
(such as cracks) to the grinding wheels and place
the user in serious danger.
Warning!
6.8 Practical tips
6.8.1 Roughing work (Fig. 11)
Important! Use the guard for grinding
(included in delivery). For the best results when
doing roughing work, apply the grinding wheel at
an angle of 30° to 40° to the grinding plane and
move it back and forth evenly over the workpiece.
6.8.2 Abrasive cutting (Fig. 12)
Important! Use the guard for cutting.
Do not tilt the angle grinder in the cutting plane
when performing cutting work. The cutting wheel
must have a clean cutting edge. To cut hard
masonry, it is best to use a diamond cutting
wheel.
Use on materials containing asbestos is
prohibited!
Anl_TE_AG_18_115_Li_SPK7_USA.indb 15 Anl_TE_AG_18_115_Li_SPK7_USA.indb 15
EN
Never use cutting wheels for roughing
work.
Note:
For optimum results, use P-X-C rechargeable
batteries with a capacity of over 3.0 Ah.
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
7.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
8. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 15 -
02.05.2022 15:26:14 02.05.2022 15:26:14