System Check - Bulldog DC Serie Manual De Instrucciones

WARNING
ALWAYS route battery cables along a path that allows the cables to be secured with zip ties.
Loose or unsecured power cables can cause serious injury or death.
1. Plan the routing path.
2. Loosely secure power cables along path.
3. Confirm power cables are protected from sharp edges, heat and moving parts. Consider chassis
flex and vibration which might damage cable.
4. Carefully inspect electrical cable routing. Zip tie and secure electrical cables. Zip ties should be
snug, but not cutting into wire insulation. Use electrical tape, pieces of rubber hose or electrical
conduit to protect electrical cables and wire harness where needed to avoid electrical cable
insulation wear or abrasion.
5. FIRST attach red (positive) battery cable, then black (negative) battery cable. Install boots as
appropriate to protect connections.

1.6.4 System Check

Upon completion of installation, check winch for proper operation. The voltage drop for the winch
motor must not exceed 10% of the nominal voltage of 12 DC.
10
CEQUENT
Installation Instructions
Figure 8 - DC9.0 / DC12.0 Wiring Diagram
Blue wire (connect motor "A")
Yellow wire (connect motor "F1")
Red wire (connect Motor "F2")
Red long wire assembly (connect battery positive +)
Black long wire assembly – Battery black
connect the ground terminal on the the motor
PERFORMANCE PRODUCTS, INC. •
™
Black wire assembly (connect motor's
ground terminal and battery negative -)
Motor
Motor's grounding terminal
F4024-00 REV C (7026) 7/16