Idiomas disponibles
Idiomas disponibles
• LCD Display
High
Near
grade high
On-grade
Near
grade low
Low
• Detection mode
1. Press the On/Off key to turn on the detector.
2. Press the middle key to select the accuracy (deadband).
3. Press the top key to select the sound level.
4. Turn the detection window towards the laser beam, and move
the detector up or down according to the information given on
the LCD display. There are 5 channels of information, or grade
indicators.
A down arrow indicates you must move the detector down to
reach the laser reference; an up arrow, move it up. When a hor-
izontal line appears on the display, the detector is at the same
level as the laser beam.
5. Press the On/Off key to turn the detector off. It will automati-
cally shut off after 10 minutes if not used (and give a warning
beep).
6. Keep the detection window clean, using a soft cloth and glass
cleaner.
• Remote control mode
The detection mode has to be stopped to use the remote control
mode.
20
B
Low battery
ATTERY STATUS
Blinking: Normal volume
Solid: Loud
No horn: Mute
A
Standard
Fine
(Default mode)
The remote can be used to stop or start rotation, increase or
decrease rotation speed, and move the beam or square shot. It also
controls scanning and electronic calibration.
S
OUND
CCURACY
* Varies with laser used. Actual accuracy depends on beam diameter and
distance to the laser.
**With batteries
6.2 Remote control
Beam
1.
2. Decrease rotation speed
3. Increase rotation speed
4. Move stationary point or
square shot left/Match slope
5. Move stationary point or
square shot rightl/Match slope
• Specifications
Range*
330 ft. (100 m) in detection mode
100 ft. (30 m) in remote mode
Accuracy*
Fine
Standard ± 1/8" (2.5 mm)
Battery life
50 hours; 9V alkaline
Environmental
Waterproof (IP66+)
Size
6" x 3.25" x 1.5"; 10 oz**
(15 x 8 x 3.5 cm / 280 g**)
Remote window
3
2
Scanning
1. Scan On / Off
2. Decrease scan length
3. Increase scan length
4. Move scan left
5. Move scan right
± <1/16" (1 mm)
1
4
5
AA Battery
21
