Idiomas disponibles
Idiomas disponibles
– Plug the probe or test leads to the instrument before connecting to any
WARNING
– Do not connect the USB cable when not in use. Keep the USB cable away
– Do not expose the circuit or operate the instrument without its cover or
– Do not use exposed metal BNC or banana plug connectors. Use only the
– Do not supply any voltage when measuring resistance or capacitance in
– Do not operate the instrument if it does not operate properly. Have the
– Do not operate the instrument in wet or damp environments.
– Do not operate the instrument in any environment at risk of explosion. Do
– Keep the instrument surface clean and dry. Keep the BNC connectors dry
WARNING
– Input CH1 and CH2 direct (1:1 probe) — CAT III 300 Vrms
– Input CH1 and CH2 via 10:1 probe — CAT III 600 Vrms
– Input CH1 and CH2 via 100:1 probe — CAT III 600 Vrms
– Meter input — CAT III 600 Vrms, CAT II 1000 Vrms
– Scope input — CAT III 300 Vrms
– Voltage ratings are Vrms (50 – 60 Hz) for AC sine wave and VDC for
– Meter input - From any terminal to earth ground - CAT III 600 Vrms
– Scope input - From any terminal to earth ground - CAT III 300 Vrms
[1]
Keysight U1610/20A User's Guide
active circuit for testing. Before disconnecting from the instrument,
remove the probe or test leads from the active circuit.
from any probe, test lead, or exposed circuitry.
while power is being supplied.
insulated voltage probes, test leads, and adapters supplied with the
instrument.
multimeter mode.
instrument inspected by qualified service personnel.
not operate the instrument in the presence of flammable gases or flames.
especially during high-voltage testing.
Maximum Input Voltages
[1]
Vrms
[1]
Vrms
,CAT I 3540 Vrms
DC applications.
Maximum Floating Voltage
Refer to the respective probe's manual for more information on the specification.
[1]
[1]
, CAT II 1000
[1]
, CAT II 1000
5
