Idiomas disponibles
Idiomas disponibles
EN
Observe the following instructions when connecting the charger:
• Use suitable measuring instruments:
• Multimeter with DC voltage measurement, 200 V or autoscale
• Amperometric clamp with direct measurement (100 A scale or higher)
• Use cables with a cross section of 6 mm.
• Always connect the charger before connecting the batteries.
• Do not use ferrules. Strip the cable ends as follows:
• Signal cable: 12 mm (0.5 mm² ... 1.5 mm²)
• Charging cable: 15 mm
Make the required connections to the charger.
7 Operation
The charger charges up to two batteries: One house battery (B1) and one starting battery (B2), with priority charging
to the house battery.
The charger starts charging the batteries under the following conditions:
• The connected solar panels deliver a voltage of 1 V higher than the voltage of the batteries to be charged.
• The battery voltage is higher than 8 V.
The house battery will be charged with the selected curve.
The starting battery will be charged under the following conditions:
• The house battery is charged between 80 % and 100 %.
• The starting battery has a voltage of less than 12.5 V.
Every charging phase has a maximum run time with exception of the maintenance phase which constantly monitors
the state of charge (SoC) and, if necessary, delivers an impulse current to keep the battery 100 % charged.
8 Disposal
Recycling packaging material: Place the packaging material in the appropriate recycling waste bins wher-
ever possible.
Recycling products with non-replaceable batteries, rechargeable batteries or light sources:
• If the product contains any non-replaceable batteries, rechargeable batteries or light sources, you
don't have to remove them before disposal.
• If you wish to finally dispose of the product, ask your local recycling center or specialist dealer for de-
tails about how to do this in accordance with the applicable disposal regulations.
• The product can be disposed free of charge.
6
