Makita ML010G Manual De Instrucciones página 10

Indication of the remaining battery
capacity
When the battery in use runs out, the appliance
switches to another battery automatically.
When switching the battery, the all indicators of the
installed batteries will light up.
Color of the indicator
Green
Red
When all of the batteries run out, the indicator of the last
one will blink in red.
Appliance / battery protection
system
The appliance is equipped with the protection system.
This system automatically cuts off power to extend
appliance and battery life. The appliance will automati-
cally stop during operation if the appliance or battery is
placed under one of the following conditions.
Overload protection
When the appliance is operated in a manner that
causes it to draw an abnormally high current, the appli-
ance automatically stops without any indication. In this
situation, remove and install the battery cartridge when
using with DC power, or push the breaker restart button
when using AC power. Then turn the appliance on to
restart.
► Fig.6: 1. Breaker restart button
Overdischarge protection
When the battery capacity becomes low, the LED
lights go out except a part of LEDs as illustrated. Then
approximately five to ten minutes later, the system auto-
matically cuts off power. In this situation, remove the
battery cartridge from the appliance and charge it.
► Fig.7
Self-righting design
The appliance can recover from the tilted position if the
angle is 80 degrees or smaller from the perpendicular
position. The standing angle of the appliance varies
depending on the conditions of the ground and the
power supply to be used.
► Fig.8
Hole for padlock
For anti-theft of battery cartridges, hole for padlock is
provided.
► Fig.9: 1. Hole for padlock
Battery capacity
Battery capacity is remaining.
There is no battery capacity.
(Run out of battery)
OPERATION
CAUTION:
This appliance is intended for
commercial use. Do not use the appliance for
household purpose.
Turning on / off the appliance
Press the power switch button to turn on the appliance.
Press the power switch button again to turn off the
appliance.
► Fig.10: 1. Power switch button
NOTE: The appliance turns on at the same mode as
the last setting.
Changing brightness
Press the brightness change button while the appliance
is operating. The brightness decreases every time you
press the brightness change button. The brightness
will return to the highest when operating in the lowest
brightness.
► Fig.11: 1. Brightness change button
Changing lighting area
Press the lighting area change button while the appli-
ance is operating.
► Fig.12: 1. Lighting area change button
The lighting area changes every time you press the
lighting area change button as illustrated.
► Fig.13
Using with AC power
WARNING:
cord or plug is damaged.
WARNING:
greasy hand.
WARNING:
connected from the appliance while the power is
supplied from the mains. Small children may put the
live plug in their mouth and cause injury.
WARNING:
into your mouth. Doing so might cause an electric
shock.
WARNING:
of the main power supply corresponds with that
of the appliance.
WARNING:
grounded.
When using the appliance with AC power, use the
power cord supplied with the appliance.
Insert the plug to AC inlet of the appliance and then
insert the other end to an outlet.
► Fig.14: 1. Power cord 2. Socket cover (AC inlet)
3. Plug (for the appliance) 4. Plug (for an
outlet)
10 ENGLISH
Never use the appliance when the
Do not handle the plug with wet or
Do not leave the power cord dis-
Do not put the live plug or cord
Make sure that the voltage rating
An outlet that is plugged must be