Makita ML010G Manual De Instrucciones página 6

Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Only for EU countries
Ni-MH
Due to the presence of hazardous com-
Li-ion
ponents in the equipment, waste electrical
and electronic equipment, accumulators
and batteries may have a negative impact
on the environment and human health.
Do not dispose of electrical and electronic
appliances or batteries with household
waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and on accumulators and batteries
and waste accumulators and batteries,
as well as their adaptation to national law,
waste electrical equipment, batteries and
accumulators should be stored separately
and delivered to a separate collection point
for municipal waste, operating in accor-
dance with the regulations on environmen-
tal protection.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Take particular care and attention.
Optical Radiation (UV and IR).
Minimize exposure to eyes or skin.
Do not stare at operating lamp.
Use appropriate shielding or eyes
protection.
Do not use the appliance in the rain, snow,
humid or wet condition when using with
AC power.
Breaker restart button.
Remark
This product contains light sources of energy efficiency
class <C> and <D>.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
This tool should be grounded while in use to protect
the operator from electric shock. Use only three-wire
extension cords which have three-prong grounding-type
plugs and three-pole receptacles which accept the
tool's plug.
SAFETY WARNINGS
IMPORTANT SAFETY
INSTRUCTIONS
WARNING:
Read all safety warnings and
all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS.
When the appliance is not in use, always
1.
switch off, and unplug / remove the battery
cartridge from the appliance.
Do not cover the lamp, or clog the vent of the
2.
appliance with cloth or carton, etc. Otherwise it
may cause a flame.
Do not use the appliance in the rain, snow,
3.
humid or wet condition when using with AC
power.
4. Do not expose the appliance to hard rain or
snow. Never wash it in water. Otherwise water
may get in to the appliance and malfunction result.
5. Do not use the appliance in explosive atmo-
spheres, such as in the presence of flammable
liquids, gases or dust.
6. Appliance plugs must match the outlet. Never
modify the plugs in any way. Use of unmodified
plugs and matching outlet will reduce risk of elec-
tric shock.
When operating the appliance, avoid body
7.
contact with earthed or grounded surfaces
such as pipes, radiators, microwave ovens, or
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded.
8. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the appliance.
Keep cord away from heat, oil, sharp edges
or moving parts. Damaged or entangled cords
increase the risk of electric shock.
9. If the external flexible cable or cord of this
luminaire is damaged, it shall be replaced by a
special cord or cord exclusively available from
the manufacturer or his service agent.
10. Do not stare at the source of light directly.
11. Do not handle the plug with wet or greasy
hand.
12. Always place the appliance on a level and sta-
ble place. Otherwise a falling accident may occur.
13. Always place the appliance in upright position.
14. The light source of this luminaire is not
replaceable; when the light source reaches
its end of life the whole luminaire shall be
replaced.
15. Do not leave the power cord disconnected
from the appliance while the power is supplied
from an outlet. Doing so might cause an electric
shock.
6 ENGLISH