MO-EL 793 Uso Y Mantenimiento página 7

Model
791-791LG
Power 220-240 V ~
supply 50-60 Hz
Power
1 x 2000 W
Lamps 1
Range 9-12 m²
Weight 2.2 kg
4. USE INSTRUCTIONS
The Industrial infrared heater was designed for zone heating on large premises. Production
departments, churches, gymnasiums are ideally application sites. With high efficiency on
heating from long distance, a compact size and a light weight a wide range on installation
can be easy made. The comfort is immediate, no preheating is necessary and this can give a
large cost saving on wide air volume or where there is discontinuous presence. The radiant
heating give a pleasant comfort and the absolute silence is assured without moving parts.
Without air movements there isn't the spreading of particles or dust.
Switch on the heater simply by connecting to the power supply.
•
Do not touch the metallic parts when the heater is working.
•
Ensure that the rays of the heater are directed towards the area it is wished to heat. If
•
necessary, change the angle of inclination by loosening the screws of the support or the
modules.
In unoccupied premises it is recommended that the heating system is switched off by
•
disconnecting from the electrical supply.
Avoid exposing skin to the rays of the appliance for distances less than 50 cm.
Avoid exposing eyes to the rays of the appliance for distances less than 2.70 m.
All users should be made aware of all aspects of operation and safety and these
instructions should be retained for reference.
5. MAINTENANCE
The IR Industrial Heaters contain no moving parts and therefore very little maintenance is
required other than to ensure that there is no excessive build-up of dust/dirt on the reflec-
tors or emitters as this can cause overheating and premature emitter failure. To clean the
appliance, wipe off with a damp cloth. Wait until it is completely dry before connecting to
the power supply.
6. EMITTER REPLACEMENT
The emitters used in the IR heater are robust and if knocks and shock vibrations are avoided,
they will last for around 3000 hours. They should be substituted even before if there are
signs of aging. Due to the special sealing and anti-shock design of the heater, the emitters
are not intended to be user replaceable. Please ensure that all emitters are replaced via the
Mo-El service network.
All manuals and user guides at all-guides.com
792-792LG 793-793LG
220-240 V ~ 380-415 V ~
50-60 Hz
2 x 2000 W
2
12-16 m²
3.0 kg
794
220-240 /
220-240 V ~
50-60 Hz 50-60 Hz
3P+N
3 x 2000 W
1 x 1500 W
3 1
16-20 m² 7-9 m²
3.8 kg 2.2 kg
7
795 796
220-240 /
220-240 V ~ 380-415 V ~
50-60 Hz 50-60 Hz
3P+N
2 x 1500 W
3 x 1500 W
2 3
9-12 m² 12-15 m²
3.0 kg 3.8 kg
Table 2