- indicator C lights up GREEN
All manuals and user guides at all-guides.com
indicating that the battery is being
charged
- when the battery is fully charged,
indicator C turns off (after
approximately 3 hours)
- the lithium-ion battery can be
charged at any time (interrupting
the charging procedure does not
damage the battery)
- the lithium-ion battery does not
have to be empty before charging
(no "memory-effect" as with nickel-
cadmium batteries)
- the tool cannot be used during
the charging procedure; it is not
defective when inoperative during
the charging procedure
- if you anticipate long periods of non-
use for the tool, it is best to unplug
the charger from its power source
• On/off 9
• Changing direction of rotation q
- when not properly set in left/right
position, switch D 2 cannot be
activated
! change direction of rotation
only when tool is at a complete
standstill
• Changing bits w
- push bit to end position in bitholder
G
! do not use bits with a damaged
shank
• Automatic spindle-lock
Allows you to manually tighten or
loosen screws, when necessary e
• LED-light r
LED-light H automatically lights on
when activating switch D, even when
switch E is in the middle (locking)
position
• Bit storage J 2
Offers storage for 2 bits at the front
• Battery level indicator
When indicator C 2 lights up RED
while switch D 2 is depressed half
way, then the battery has less than
30% of its capacity and should be
charged
• Two handle positions t
• Battery protection
Switches off the tool automatically
when
the battery temperature gets too high
(> +65°C)
the lithium-ion battery is nearly empty
(to protect against deep discharge)
APPLICATION ADVICE
• Use the appropriate bits y
! do not use damaged bits
! only use bits with hexagon shaft
• When turning in a screw at/near the
cross cut end or an edge of wood, pre-
drill a hole in order to avoid cracking
of the wood
• For an optimal use of the tool a steady
pressure on the screw is required,
especially while removing
• When screwdriving in hard wood one
should pre-drill a hole
• For more information see
www.skil.com
MAINTENANCE / SERVICE
• This tool is not intended for
professional use
• Keep tool and charger clean
! unplug charger from power
source before cleaning
• If the tool/charger should fail despite
the care taken in manufacturing and
testing procedures, repair should be
carried out by an after-sales service
centre for SKIL power tools
- send the tool or charger
undismantled together with proof
of purchase to your dealer or
the nearest SKIL service station
(addresses as well as the service
diagram of the tool are listed on
www.skil.com)
• Be aware that damage due to overload
or improper handling of the tool will
be excluded from the warranty (for
the SKIL warranty conditions see
www.skil.com or ask your dealer)
14
