S1156009-38,T26CS_1.fm Page 15 Wednesday, April 6, 2016 1:15 PM
•
Move the choke lever to Half Choke position as soon
as the engine sounds as if it is trying to start.
•
Pull starter cord while trigger is in the full throttle
position until engine starts.
•
Once engine is started leave the choke lever in Half
choke position for 20 seconds. Then move the choke
lever to RUN position.
If engine does not start move the choke lever to Full
Choke position and do the steps again.
WARNING! When the engine is started
!
with full throttle the cutting attachment
will start to rotate immediately.
STARTING AND STOPPING
Always pull starter cord straight out. Pulling the starter at
an angle will cause cord to rub against the eyelet. This
friction will cause the cord to fray and wear more quickly.
Always hold the starter handle when cord retracts. Never
allow cord to snap back from extended position. This
could cause cord to snag or fray and also damage the
starter assembly.
Warm engine
•
•
Stopping
Stop the engine by switching off the ignition.
CAUTION! The stop switch automatically returns to the
start position. In order to prevent unintentional starting,
the spark plug cap must be removed from the spark plug
when assembling, checking and/or performing
maintenance.
Set the choke control in the RUN position.
Then grasp the starter handle with your right hand and
pull the starter cord.
–
English
15