Idiomas disponibles
Idiomas disponibles
7. The 3 cleaning modes.
Automatic
Deep cleaning
Along the skirting boards
Auto» button
Powerful» button
Edge» button
The cleaning is adapted to
Place the robot on the area to
The robot will perform its
your room and your floor
be cleaned and it will increase
cleaning cycle starting along the
types automatically.
the area to be cleaned.
baseboards.
Note :
A. Once the deep cleaning or skirting board cleaning has been completed, the robot will return to automatic mode to finish its work.
B. Regardless of the mode it is in, the robot will stop cleaning if you press the «start / pause» button on the remote control or directly
on the button on the appliance.
Maintenance of your appliance
1. Cleaning the side brushes
If the side brushes are dirty, remove them and wash them in clean water. Then make sure they are dry before reinstalling them on
the machine. If they are damaged, replace them with new ones.
Note : When changing the side brushes, match the «L» and «R» signs on the side brushes with the «L» and «R» signs on the robot.
Note : To ensure that your machine works properly, it is recommended that you change your consumables every 6 months.
2. Cleaning the dust pan and filter
- Open the dust container compartment and remove the container.
- Check that the robot's suction pipe is not blocked and clean it with a cloth.
- Open the dust container and empty it, then run it under water if necessary. Wait until it is completely dry before reinstalling it.
- Remove the filters by blowing on them and tapping them lightly. Do not wash them with water.
- Re-assemble the filter and pre-filter before inserting them into the dust container to avoid any malfunction.
Note : It is recommended to clean the dust pan at least once a week and the filters every 15 days. Do not wash them with water.
Make sure that they are reassembled afterwards to avoid damaging the robot.
