Idiomas disponibles
Idiomas disponibles
5.
Use a piece of wood to prevent the movement of
the blade.
6.
Remove the mounting screw with a wrench or
socket.
7.
Remove the blade.
8.
Install the new blade. Make sure that the arrows
engage the holes in the blade.
9.
Put in the mounting screw and tighten it.
9.3
STORE THE MACHINE
• Clean the machine before storage.
• Make sure the motor is not hot when you put the
machine into storage.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
You may lower the handle(s) before you put the
machine into the storage.
1.
Fully loosen the handle fasteners on the sides of
the handle(s).
2.
Fold away the handle(s).
3.
Do not pinch or trap the cables.
10
TROUBLESHOOTING
Problem
Possible cause Solution
The handle is
The bolts are
not in position.
not engaged
correctly.
The machine
The battery ca-
does not start.
pacity is low.
The start han-
dle is defective.
The battery key
is not put in.
The machine
The lawn is
cuts grass un-
rough.
evenly.
The blade
height is not set
correctly.
English
Problem
The machine
does not mulch
correctly.
The machine is
hard to push.
There is a high
vibration in the
machine.
Adjust the
height of the
handle and
make sure that
The machine
the bolts and
stops during
nuts are aligned
mowing.
correctly.
Charge the bat-
tery pack.
Replace the
start handle.
Put in the bat-
tery key.
Examine the
mowing area.
Move the
wheels to a
higher position.
* If you cannot find the solution to these problems, go
to the service center.
13
Possible cause Solution
Wet grass clip-
Wait until the
pings attach to
grass dries be-
the deck.
fore mowing.
The mulch plug
Install the mulch
is missing.
plug.
The grass is too
Increase the
tall, or the blade
blade height.
height is too
low.
The grass
Empty the grass
catcher and the
clippings from
blade drags in
the grass catch-
thick grass.
er.
The blade is un-
Replace the
balanced and
blade.
worn.
The motor shaft
1.
Stop the
is bent.
motor.
2.
Remove
the safety
key and
battery
pack.
3.
Disconnect
the power
source.
4.
Inspect for
damage.
5.
Repair the
machine
before you
start it
again.
The blade
Increase the
height is too
blade height.
low.
The battery
Charge the bat-
pack is out of
tery pack.
power.
The grass clip-
Remove the
pings attach to
battery pack
the deck or the
and check the
blade.
deck.
Operation tem-
Cool the ma-
perature of the
chine.
machine is too
high.
EN
