Defrost - Sagi 3241730 Manual De Uso

BLACKOUT ALARM
OPEN DOOR ALARM
In case of door open the display visualises the message [dA] alternating with the current visualisation whilst
the buzzer sounds the event with a beep of five seconds repeated every 10.
The alarm will reset upon the closure of the door and is registered in memory (high frequency flashing
defrost LED).
HIGH CONDENSATION TEMPERATURE ALARM
If the condensation temperature is too high, due to dirty condenser, the label [HtC] and the room temperature
alternate on the display.
The buzzer sounds.
The buzzer can be turned off by pressing the key
The visual warning signal stays on until the condensation tempertaure returns to normal range.
HIGH PRESSURE ALARM
If the refrigerating appliance pressure is above the specified limit, the label [HP] and the room temperature
alternate on the display.
The buzzer sounds.
The buzzer can be turned off by pressing the key
The visual warning signal stays on until the card is set to stand-by.
! If the problem causing the alarm reoccurs on restarting the system, the signal [HP] will be displayed again.
In this case, all the relay outputs are de-activated except the condenser fan output.
Defrost may be either manual type or automatic type.
Manual defrost
The defrosting process can be stopped manually by pressing the
process is stopped, a signal blinks on the label display [ndF].
The defrost led blinking at high frequency indicates a blackout
Pushing the enter button the [bLO] label will be visualised on the display.
Pushing the enter button the maximum temperature recorded in the chamber
will be visualised on the display.
Pushing the enter button the defrost led is reset to standard operation.
The display shows [rES] after the abnormal event.
Push the button defrost for 4 sec seconds to immediately activate the defrost
cycle.
Just before the defrosting process begins, the temperature of the blocked cell
is displayed.
.
.
key again for 4 seconds. When the
16
DEFROSTING