AERMEC MODUCONTROL Manual De Instrucciones página 72

Code Code
Alarm Pre-alarm
37 137
40 140
41 141
42 142
43 143
44 144
45 145
46 146
47 147
51 151
54 --
55 155
-- 156
57 157
58 158
59 159
60 160
61 161
62 162
63 163
64 164
65 165
66 166
67 167
68 168
69 169
70 170
71 171
72 172
73 173
74 174
75 175
76 176
77 177
78 178
79 179
72
EN
IMDCFJ. 12.05 6343841_03
Causes
DC Bus over-voltage
PFC Converter Fault
Error in the PFC module
Over current in acceleration mode
Overload
Over-current at constant speed
Over current in deceleration mode
Compressor not connected
correctly
No communication
Cooling fin temperature sensor
error
Anomalous condition
Cycle reverse valve faulty
Water inlet high temperature
Cycle reverse due to high
temperature of the pressing line
gas
Reading error of the DHW control
board remote probe.
Outdoor air temperature probe
reading error
Inlet water probe
no condenser
(ONLY WRL)
Output water probe
no condenser
(ONLY WRL)
Over-current
Compressor motor overload
Over-voltage
Under-voltage
Drive overheating
Drive underheating
Hardware over-current
Compressor overheating
Reserved
CPU error
Default parameters
DC bus ripple
No communication between invert-
er and uPC
Drive temperature sensor fault
Self-configuration failed
Inverter drive disabled
Motor phases error
Cooling fan
Inverter faulty
Speed fault
Notes
(code APY 6)
Software error (code APY 9)
Software error (code APY 10)
(code APY 11)
Software error (code APY 12)
Software error (code APY 13)
(code APY 14)
(code APY 15)
(code APY 16)
Protection frequency against over-current and overheating
reduced. (code APY 20)
The cycle reverse valve could be faulty or broken. (see
8.4)
The water inlet temperature has exceeded the set_install-
er (H) parameter value. Probable boiler presence on
same plant. At the third intervention of the pre-alarm, the
machine goes into alarm mode and blocks
This pre-alarm indicates the intervention of defrosting
due to cycle reverse without having respected the times
between cycle reverses. Cycle reverse has been triggered
by the pressing line gas high temperature partialisation
threshold being exceeded, set_factory (6)-set_factory (4)
= default 130°. This pre-alarm does not cause compressor
stop and does not have a limited number of interventions
This pre-alarm indicates a remote probe fault or a commu-
nication problem with the DHW control board. The alarm is
only active if the parameter (0)=2 or the parameter (8)=4 in
the menu with password = 30
This pre-alarm indicates an outdoor air temperature probe
fault when the DCP is present or the machine is in heat
pump mode.
This pre-alarm indicates a condenser inlet water tempera-
ture probe fault
This pre-alarm indicates a condenser outlet water tem-
perature probe fault
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter
Carel Inverter