Idiomas disponibles
Idiomas disponibles
Slide slot of clamping spindle
1. TO REPLACE THE BRUSHES (SEE FIG. H)
If the carbon brush is worn and less than 5mm, it needs to
be replaced.
Remove the screws securing the motor brush cover. Remove
the cover, gently lift out, and pull the spade connector
free. Hold back the coil spring and slide the worn brush
out of the housing, carefully release the spring. Locate the
replacement brush, (in the same orientation) whilst again
holding back the coil spring. Ensure the brush is located and
free to move, release the spring; it should now sit within the
groove on the brush. Re-attach the spade connector to the
terminal, replace the cover and secure.
NOTE: Brushes should be replaced in pairs. If any query,
contact the Helpline.
EN
21
