Denver IR-100 Manual Del Usuario página 6

Standard encrypted network
1. To enter the network key (password), rotate the SELECT control to move the cursor through the
characters to be selected and press on it to confirm.
2. The key that is entered will be displayed in the upper part of the display.
WPS-encrypted network
WPS-encrypted networks are identified by their network names as soon as the unit starts searching for
available network connection. Select one of the following connection methods:
Push button
-
The radio prompts you to press the connection button on the router, it then scans for a
corresponding network and establishes the connection.
Pin (code number)
-
The radio generates an 8-digit code number. Enter this code number into the wireless router or
access device.
WPS
-
Enter the network key for a standard encrypted network.
Note: Additional information on setting up the WPS-encrypted networks can be obtained in the user
manual of your WPS router.
Completion
The radio establishes connection with the selected network.
If connection is failed, the radio returns to the previous display and prompts you to retry.
If an existing network connection is lost, it would automatically attempt to retry for reconnection.
Equaliser
Several preset EQ modes are available: Normal, Flat, Jazz, Rock, Movie, Classic, Pop, News.
In addition, user-defined settings are possible you can set up the equalizer with bass, treble and
loudness according to your personal taste.
Network
View settings
You can check the following information on the currently connected network:
Active connection, MAC address, WLAN region, DHCP.SSID, IP address, subnet mask, gateway
address, first and second DNS.
WLAN region
Select a WLAN region for optimal WLAN connectivity:
Most of Europe, USA, Canada, Spain, France, Japan, Singapore, Australia, Republic of Korea.
Manual settings
Select either a wireless or wired connection and activate/deactivate DHCP.
Network profile
The radio stores the last four wireless networks that were connected and attempts each time to
reconnect to one of them. You can view a list of the registered networks. From here you can delete
unwanted networks by turning the SELECT control followed by pressing on it to confirm delete.
Language
The default language is English.
To select other languages, rotate the SELECT control followed by pressing on it to confirm.
ENG-5