Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing application
tool
Optional accessory
WARNING:
Do not install application tool
upside down. Installing application tool upside down
may damage the tool and cause serious personal injury.
NOTE: Install application tool in the correct direc-
tion according to your work. Application tool can be
installed at an angle of every 30 degree.
To Install an application tool (optional accessory), put the appli-
cation tool on the tool flange so that the protrusions of the tool
flange fit in the holes in the application tool. Then secure the
application tool by tightening the bolt firmly with the hex wrench.
Fig.6
► 1. Protrusions of the tool flange 2. Holes in the
application tool 3. Application tool installation bolt
Fig.7
► 1. Application tool installation bolt 2. Hex wrench
3. Tighten
To remove the application tool, loosen and remove the
application tool installation bolt using a hex wrench and
then take off the application tool.
When using the tool as a sander, set a sanding paper
on the sanding pad (hook and loop fitting).
Make sure that their shape and dust extraction holes
match each other when setting.
3
1
Fig.8
► 1. Sanding pad 2. Tighten 3. Sanding paper
To remove the sanding paper, raise its end and peel it off.
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
Fig.9
► 1. Application tool installation bolt 2. Holes in the
application tool 3. Adapter (required for some appli-
cation tools) 4. Protrusions of the tool flange
Hex wrench storage
Fig.10
► 1. Hex wrench
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
7 ENGLISH
2
Tabla de contenido
