Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing application
tool
Optional accessory
WARNING:
Do not install application tool
upside down. Installing application tool upside down
may damage the tool and cause serious personal
injury.
CAUTION:
Clean up dust and perform lubri-
cation on the moving part of the lock lever from
time to time. Otherwise dust may accumulate in the
moving part of the lock lever and hinder its smooth
movement.
CAUTION:
Be careful when closing the lock
lever.
Hold the tool firmly when installing or removing
the application tool. Do not put your hand around
the original position of the lock lever. The lock
lever may close suddenly and pinch your finger.
NOTICE:
Install application tool in the correct
direction according to your work. Application tool
can be installed at an angle of every 30 degree.
NOTICE:
Do not start the tool while the lever
opens. The tool may be damaged.
1.
Open the lock lever fully until it sounds a click.
Remove the holder bolt.
When the lock lever is fully opened, the position of the
lock lever is maintained even if you release your hand.
► 1. Lock lever 2. Holder bolt
2.
Put an application tool (optional accessory) onto
the tool flange. And then, insert the holder bolt until it
stops.
1
2
► 1. Holder bolt 2. Application tool 3. Tool flange
4. Application tool (sanding pad)
8 ENGLISH
1
2
1
3
4
Tabla de contenido
