Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing or removing driver bit/
socket bit
Optional accessory
12 mm
(15/32")
Use only the driver bit/socket bit shown in the figure. Do
not use any other driver bit/socket bit.
1
► 1. Driver bit 2. Sleeve
To install the driver bit, pull the sleeve in the direction of
the arrow and insert the driver bit into the sleeve as far
as it will go.
Then release the sleeve to secure the driver bit.
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
NOTE: After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.
OPERATION
CAUTION:
When bending the tool to use in
the pistol shape or straightening to use in the
straight shape, do not hold the bendable part of
the tool. Failure to do so may cause your hand and
fingers to be pinched and injured by this part.
9 mm
(3/8")
2
1
2
► 1. Straight shape 2. Pistol shape
The tool can be used in two ways; a straight shape and
a pistol shape which are selectable according to the
conditions of workplace and screwdriving.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
N•m
(ft•lbs)
20
(15)
15
(11)
2
10
(7)
5
(4)
0
1. Fastening time (second) 2. Fastening torque
3. Proper fastening torque corresponding to each bolt
diameter
6 ENGLISH
M8(5/16")
M8(5/16")
M6(1/4")
M6(1/4")
1
2
3
1
3
Tabla de contenido
