Optional Accessory - Makita DTW190 Manual De Instrucciones

Move the O-ring out of the groove in the impact socket
and remove the pin from the impact socket. Fit the
impact socket onto the square drive so that the hole in
the impact socket is aligned with the hole in the square
drive.
Insert the pin through the hole in the impact socket and
square drive. Then return the O-ring to the original posi-
tion in the impact socket groove to retain the pin.
To remove the impact socket, follow the installation
procedures in reverse.
Installing hook

Optional accessory

► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
OPERATION
CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Hold the tool firmly and place the impact socket over
the bolt or nut. Turn the tool on and fasten for the proper
fastening time.
3
1
2
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Proper fastening torque for standard bolt
2
N•m
(ft•lbs)
180
(130)
160
(120)
140
(100)
120
(90)
100
(70)
80
(60)
60
(40)
40
(30)
20
(10)
0
0
► 1. Fastening time (second) 2. Fastening torque
Proper fastening torque for high tensile bolt
2
N•m
(ft•lbs)
130
(100)
110
(80)
90
(70)
70
(50)
50
(40)
30
(20)
10
(10)
0
0
► 1. Fastening time (second) 2. Fastening torque
7 ENGLISH
M16 (5/8")
M14 (9/16")
M16 (5/8")
M12 (1/2")
M14 (9/16")
M10 (3/8")
M12 (1/2")
M8 (5/16")
M10 (3/8")
M8 (5/16")
1 2
1
M12 (1/2")
M10 (3/8")
M12 (1/2")
M8 (5/16")
M10 (3/8")
M8 (5/16")
1 2
1
3
3