Jeep Hemlock Manual Del Usuario página 19

Parameter configuration
After turning on the display, quickly press the i button twice to access the SETTING MENU of the product use parameters;
quickly press the i button twice to exit the setting menu and restore the main menu display.
Quickly press the + or – button to select the desired value of the individual parameter and then quickly press the i button to
confirm the data entered and view the next configurable parameter.
The sequence of parameters that can be configured is shown below:
tC - TRIP - MAXS - AVG data reset
Using the value variation buttons, select the letter y and then press the + button for about 2 seconds.
S7 - Unit of measurement:
press the + or – buttons to select the unit of measurement for the speed and distance data displayed:
international metric system (Km/h and Km) or British imperial (MPH and Mile).
bL0 - Light sensitivity sensor:
press the + or – buttons to increase or decrease the value of the light sensitivity detection parameter to automatically
activate the front light and the backlight of the display screen in poor lighting conditions; selectable values between 1
(minimum sensitivity) and 5 (maximum sensitivity).
When the value is set to 0, the function is disabled: in this case, the front light and backlight of the display screen can only be
turned on manually, using the relative button.
bLI – Screen brightness:
press the + or – buttons to increase or decrease the value of the display screen brightness parameter; selectable values
between 1 (minimum brightness) and 5 (maximum brightness).
0FF - Automatic Power Off:
press the + or – buttons to set the minutes before the display is automatically switched off when the product is no longer in
use (selectable values from 1 to 9).
When the value is set to 0, the function is disabled and the display can only be turned off manually, using the relative button.
Exit the parameter setting menu by quickly pressing the i button twice, allowing the confirmation of the selected values.
CAUTION
The following parameters - displayed in the setting menu - are configured by default to allow the product to operate in
optimal conditions and in accordance with the provisions of the current regulations regarding the use of the electrically
power assisted cycle (EPAC).
In case anomalous data are highlighted on the display, contact the after-sales technical assistance service to receive
appropriate support: https://www.jeepurbanemobility.com/support/
18