Idiomas disponibles
Idiomas disponibles
CONNECTION
IMPORTANT: refrigerate the amplifi er properly. To do this, make sure that the place where it is installed has
access to airfl ow and that the slots in the chassis are free of obstructions.
-
With the amplifi er turned off, connect all CH, AUX and EMERGENCY IN audio sources and select the
LINE/MIC input type and enable/disable PHANTOM power on channels CH 1 to CH 3 using the DIP
switches on each input channel. If you are going to use the FM radio, you will need to connect an FM
receiver antenna.
-
Connect the speakers to the corresponding low impedance output* (4 Ω + COM), 100 V line* (100 V +
COM), 70 V line (70 V + COM), zones* (ZONE 1-3) or to the stereo recording output (REC OUT).
*IMPORTANT: for proper operation and performance of the equipment, use the correct power, impedance
and frequency limits. Before connecting to other equipment, be aware of the conditions required in a
HIGH IMPEDANCE (100 V) and LOW IMPEDANCE installation. More information can be found at:
-
Check that the volume and gain controls are at minimum and connect the amplifi er to power.
-
Turn on the amplifi er and activate the AUX or PLAYER input and outputs (if you are using the ZONES
zone output) you wish to use using the buttons on the front panel of the amplifi er.
-
Check the volume controls for inputs, outputs, and master volume.
-
PRIORITY: Enable priority on the desired inputs using the DIP microswitches and regulate sensitivity
using the VOX controls on the inputs.
-
Finally, adjust the equalisation using the BASS and TREBLE controls on the rear panel.
3 ZONES - 100 V LINE
EMERGENCY
EMERGENCY
100 V LINE
EMERGENCY
EMERGENCY
EMERGENCY
EMERGENCY
fonestar.com/downloads/install_fonestar_es.pdf
R
R
L
L
MAX 240 W@100 V
MAX 240 W@100 V
MAX 240 W@100 V
MAX 240 W@100 V
R
R
L
L
R
R
L
L
- 5 -
PRE OUT
PRE OUT
AMP IN
AMP IN
ZONE 4
ZONE 1
MAX 240 W@100 V
ZONE 4
ZONE 1
MAX 240 W@100 V
ZONE 3
ZONE 2
MAX 240 W@100 V
ZONE 3
ZONE 2
MAX 240 W@100 V
PRE OUT
PRE OUT
AMP IN
AMP IN
PRE OUT
PRE OUT
AMP IN
AMP IN
230 V AC
230 V CA
230 V AC
230 V CA
TOTAL (Z1 + Z2 + Z3 + Z4)
MAX 240 W@100 V
TOTAL (Z1 + Z2 + Z3 + Z4)
MAX 240 W@100 V
230 V CA
230 V AC
230 V AC
230 V CA
MAX 240 W@100 V
MAX 240 W@100 V
230 V CA
230 V AC
230 V AC
230 V CA
MAX 240 W@4
MAX 240 W@4
EN
