Idiomas disponibles
Idiomas disponibles
Programming dispensing
Press and hold down the symbol you want to program (2-3-
12), the machine will start dispensing; once the desired quantity
has been reached, release the symbol. The machine will then
stop dispensing and the quantity will be memorised. (Fig.14)
NOTE: The minimum programming value is 10 seconds.
After preparing coffee and beverages
After preparing coffee and beverages, the used capsule is
eliminated as follows:
• Lift the control lever backwards (the capsule falls into the
container provided).
ATTENTION: for correct hygiene, it is advisable to eject
the capsule immediately after use.
Empty the container regularly.
• If you want to make another coffee or beverage, insert a
new capsule and repeat the procedure, otherwise close
the lever.
• If you want to prepare a different beverage from the one
prepared previously, so as not to alter its taste, we
recommend, after expelling the used capsule, to dispense
some plain water to eliminate any possible residue.
Emptying the capsule container
After 15 coffees have been delivered, the full drawer indicator
light comes on (14) (VAP and 4D Model). This means that
further coffee can only be delivered after emptying the capsule
drawer. To do this, remove the tray (6) and empty the container.
Remove the drip grid (5) (Fig. 15), wash and dry the
components, then reassemble the tray (6) and replace it in its
position (Fig. 16)
NOTE: Wait at least 5 seconds before replacing the tray (6).
If the tray is replaced and the light (14) on the control panel
stays on, remove the tray again, wait at least 5 seconds and
put it back.
Fig. 14
5
Fig. 15
Fig. 16
31
Mod. VAP
2
12
Mod. 4D
2
12
Mod. 2D
2
14
6
6
3
3
3
